Not signed in (Sign In)

Matco Associates Inc. Specialists in Materials Engineering, Corrosion and Failure Analysis

Categories

Welcome, Guest

Want to take part in these discussions? Sign in if you have an account, or apply for one below

Vanilla 1.0.3 is a product of Lussumo. More Information: Documentation, Community Support.

Paint/Protective Coatings Engineering: Temperature test of paints and coatings

Bottom of Page

1 to 5 of 5

  1.  
    • CommentAuthorkenmcole
    • CommentTimeJan 31st 2007
     permalink
    Could you please tell me if manufacturers of paints or coatings perform any specific temperature exposure tests on their products.
    In the development laboratory are products exposed to temperature extremes and what would be a typical sample size, I.E., would sample fit into a small temperature chamber.
    • CommentAuthorDr. Zee
    • CommentTimeJan 31st 2007
     permalink
    Thermal cycling of paint and coatings are routinly performed to determine degradation and failure mechanisms that may be experienced in service at different project sites. Test results will provide critical temperatures (low and high temperature limits) and specification(expectations) requirements for the paint/coating system.
    • CommentAuthorzadnan2
    • CommentTimeAug 3rd 2008
     permalink
    Is it possible to coat diamond on brass?
  4.  permalink
    If you have such problems refer to the company that makes the products you have and they will advise on max & Min temp etc. Thay can also advise on the max water in the electorlite that the product can be applied.
    • CommentAuthoramrullah
    • CommentTimeSep 14th 2009
     permalink
    May you can direct contact with paint manufacture also please you look MSDS about this is product content when use it and how to good apply to rich out the good performance

1 to 5 of 5

  1.